Product Description

• Acid type agglomerated alumina & rutile based flux. It is featured with stable arc, uniform weld metal surface, smooth welding bead appearance. SJ501 is for the use of multiwire high speed welding up to 70m/h. Especially suitable for boiler water-wall tubes welding, twin wire single pass welding, fillet welding, butt welding and thin sheet welding. High tolerance to impurities like rust, oil, water, paint, etc. Accompany with Submerge welding wires H08A,H08MnA,H08MnMoA,H10MnSi. TOKO Flux SDS data report
• 1. Below data sheets from tests carried out in accordance to AWS and GB standard procedure. They only represent values we get under those conditions. They are not to be taken as guarantees. As to welding, individual test results may vary;depending on experience & technique, flux type, base metal,joint preparation, flux preparation, ampere, voltage, etc.

   

  2. If welding fluxes are stored in improper environment or influenced by condensed moisture, anyway, they get damp, please dry them at 300-350℃ for 2 hours before usage.

   

  3.Please clean the rust,oil,water on base metal before welding.

   

  4. Add minumum 20% new flux when using recovered flux to avoid welding defects and maintain welding performance; mechanical properties.

   

  5. Please control parameters properly, like preheat temperature,interpass temperature,cooling rate. Flux SJ101, SJ301, SJ501 etc

Payment Terms︰ T/T, L/C

Product Image